lørdag den 7. marts 2015

Hobbyking Multiwii Pro - Damaged USB connector

Some time ago, my usb connector on my Multiwii Pro got accidently ripped, when i tugged on the cable, this is a common issue with many boards with the usb connector. I purchased a new FC and parked the Multiwii together with everything else that was buggered.

Just a few days ago I stumbled on an article on how to connect the board to my PC using a FTDI basic adapter. I have on of these adapters as they are very useful when working with quad building. They are relatively cheap and can be purchased her on Ebay.


Grab your FTDI basic

Connect the cables

Find J2/serial port
GND on the basic goes to GND on the FC
VCC on Basic goes to +5v on the FC
TXD on the basic goes to RXD on the FC
RXD on the basic goes to TXD on the FC
DTR on the Basic goes to DTR on the FC

Connect the usb cable from the PC to the USB port on the basic, Remember to download the drivers for the FTDI controller from her and install them.

Your flight controller should fire up,

 Choose the correct com port and you can again update your firmware using the FTDI basic

Now you can start mission planner, choose the correct COM port and press connect, you are now able to use your board like you did before


Well hope it helped....